Shortly before Christmas I decided to dig out my 28mm Colonial Sudan armies and pep them up. The main intention was to rebase the forces entirely so that they could be used for different rule sets with different sabot bases.
To this end I ordered a batch of 5mm and 10mm rare earth magnets, along with 20mm and 25mm steel washers. I then spoke with Simon at Blotz to have a batch of unit trays made which would take the washer based figures with holes for the magnets beneath.
After spending a long weekend stripping figures from bases and sticking them to the recently received washers I then applied the basing material and painted the figure bases ready for the new movement trays.
The movement trays arrived within a day or so (Simon and Sue’s service through Blotz is second to none and highly recommended), and I started to insert the magnets and test out the based figures. The movement trays were perfect, taking the washer based infantry cleanly and being a perfect fit for the rare earth magnets.
It was only then that I noticed that the figure bases weren’t’ ‘sticking’ to the magnets. After a short while of mucking around and testing various bases, magnets (and other magnets, and other washers) I realised that the washers which I had bought, and spent days lovingly rebasing my figures onto weren’t in fact attracted to magnets.
After a few minutes of silent expletives I did a quick google search and found that not all stainless steel works with magnets. Who knew? (Well as is quite obvious, I didn’t)
So before I started the long task of rebasing the entire Sudanese army (again), I did some experimenting looking for a quick fix solution. I tried a few solutions, which included basing the washer based figures on top of other steel washers (worked because these did work with magnets) – these unfortunately stood a bit too tall of the movement tray, but could be considered a viable solution. Eventually I’ve settled on basing the washer figures on top of a thin circle of steel paper which does stick to magnets, and doesn’t make the bases stand too high above the movement tray. OK, so this does take a little time using the 25mm hole punch and sticking and trimming the bases, but it’s a lot quicker than the alternative, and definitely a lot let disheartening than completely rebasing the army again.
Blotz can be found at most of the bigger Wargames shows in England, alternatively check them out on their website.